Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

%STANDBY-3-DUPADDR: Duplicate address

Hi netpro,

i got the log file as below.

Jul 10 14:30:17.093: %STANDBY-3-DUPADDR: Duplicate address 172.100.83.253 on Vlan100, sourced by 0000.0c07.ac53

but, i have checked my vlan 100. i have not conflict with the HSRP.

any idea ?

your reply will be highly appreciated.

regards,

Jack

5 REPLIES
Cisco Employee

Re: %STANDBY-3-DUPADDR: Duplicate address

Hi Jack,

Follow the troubleshooting tips found at "HSRP Standby IP Address Is Reported as a Duplicate IP Address"

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094afd.shtml#t20

This should allow you to track down the underlying issue causing the messages. The real issue is not necessarily misconfigured HSRP. If you get stuck, please post your findings and the relevant portions of the device configs for further assistance.

Hope this helps! Please rate all posts.

Regards, Martin

New Member

Re: %STANDBY-3-DUPADDR: Duplicate address

Hi Jack

Potentially a STP loop could cause this problem.

Regards

Mark

New Member

Re: %STANDBY-3-DUPADDR: Duplicate address

Hi Mark,

so, i just focous to that vlan which duplicated with standby interface and tracing any switch/hub or router plug into my access switch ?

your reply will be highly appreciated .

thanks

regards,

Jack

Cisco Employee

Re: %STANDBY-3-DUPADDR: Duplicate address

Hi,

I would start to do a layer2 troubleshooting, because a (transient) STP loop is the most likely cause as mentioned in the previous post. So check your switches, trunks and so on to spot possible STP issues. Additional routers connected to the VLAN can be ruled out rather quickly, if the do not have the same HSRP group as the system logging the messages from your initial post.

Regards, Martin

New Member

Re: %STANDBY-3-DUPADDR: Duplicate address

Hi Martin,

yes, i do agree with you. i start troubleshooting from L2. i detected 1 HP procurve switch connecting into my Access Switch.

Question .

How can i confirm this switch is causing the loop ?

thanks .

regards,

Jack

314
Views
2
Helpful
5
Replies