Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

standby cold for supervisor engine X4013+ with cisco 4507R

Dear sir,

Please advise why we configure redundancy , mode sso but it appear as rpr and it shown standby cold ? by right it should show standby hot and mode sso.

thanks and appreciation.

2 REPLIES
Purple

Re: standby cold for supervisor engine X4013+ with cisco 4507R

I would go thru this and see if you are missing anything and if you have the minumum required IOS .

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/50sg/configuration/guide/RPR.html

Re: standby cold for supervisor engine X4013+ with cisco 4507R

Hi,

SSO is supported on a switch provided that code be of minimum 12.2(20)EWA version.

Please check the IOS version of the switch.

597
Views
4
Helpful
2
Replies