Static ARP entry on Cisco IOS --> Can I specify it to point to one port?
Hi, I want to set up a static ARP entry in cisco IOS so that it will assign the MAC address in the ARP entry to a specific interface on the swich no matter what. Is this possible and if so how would I do it? Thanks in advance.
Re: Static ARP entry on Cisco IOS --> Can I specify it to point
Hi, it can't be done specifying a physical interface but you can associate the ARP to a VLAN, do it this way and then what the switch does is to look for the MAC table for that VLAN and send the frame to the port where the MAC is associated (if any), if not it will flood the frame out of that vlan. This works!
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.