I'm very new to Cisco, so bear with me. I am setting up an 1812 and I'm having trouble using DHCP to distribute static addresses. I have had quite a bit of experience doing this with other routers and thought I had it right. Using SDM, I defined the DHCP pool and created the DHCP bindings but the servers didn't pick up thise addresses and I had to configure one each separately. I would like to have DHCP do the job since it would also update the DNS settings when necessary.
I tried allocating the entire subnet to DHCP and that didn't work. Then I allocated a small block to DHCP with the bindings outside the block, this is the way I would normally configure static DHCP. Neither way worked, what am I missing?
Thanks for the quick reply. My problem is not entering the address assignments, the servers are not getting the assignments, they get a pool address. I have temporarily setup each server but would like to use the 1812. Here are my assignments from the sdmconfig.txt, is this correct?
no ip dhcp use vrf connected
ip dhcp excluded-address 192.168.123.1 192.168.123.49
ip dhcp excluded-address 192.168.123.151 192.168.123.254
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.