Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

static ip route

Dear Sir,

I have the following commands in my 3560 switch:

ip classless

ip route 0.0.0.0 0.0.0.0 10.106.242.57

ip route 10.106.13.0 255.255.255.240 10.106.13.249

ip route 10.106.13.16 255.255.255.248 10.106.13.17

#sh ip route

Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP

D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area

N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2

E1 - OSPF external type 1, E2 - OSPF external type 2

i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2

ia - IS-IS inter area, * - candidate default, U - per-user static route

o - ODR, P - periodic downloaded static route

Gateway of last resort is 10.106.242.57 to network 0.0.0.0

10.0.0.0/8 is variably subnetted, 3 subnets, 3 masks

S 10.106.13.0/28 [1/0] via 10.106.13.249

C 10.106.242.56/29 is directly connected, FastEthernet0/24

C 10.106.13.192/26 is directly connected, Vlan1

S* 0.0.0.0/0 [1/0] via 10.106.242.57

I need to access 10.106.13.20/29 and 10.106.13.21/29, but I cannot.

Please help. Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: static ip route

Joseph

The explanation of your situation is fairly simple. You have configured 3 static routes and 1 of them specifies a next hop addresses that the router does not know how to reach. Your route:

ip route 10.106.13.16 255.255.255.248 10.106.13.17

which would include the .20 and .21 specifies a next hop address of 10.106.13.17 and the router does not know how to reach that next hop address and so does not insert the static route into the routing table. If you specify a reachable next hop address then the .20 and .21 would be reachable.

HTH

Rick

2 REPLIES
Cisco Employee

Re: static ip route

It is because IP 10.106.13.17 is not in the routing table.

Can you provide a network topology?

HTH,

jerry

Hall of Fame Super Silver

Re: static ip route

Joseph

The explanation of your situation is fairly simple. You have configured 3 static routes and 1 of them specifies a next hop addresses that the router does not know how to reach. Your route:

ip route 10.106.13.16 255.255.255.248 10.106.13.17

which would include the .20 and .21 specifies a next hop address of 10.106.13.17 and the router does not know how to reach that next hop address and so does not insert the static route into the routing table. If you specify a reachable next hop address then the .20 and .21 would be reachable.

HTH

Rick

308
Views
0
Helpful
2
Replies
CreatePlease to create content