Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Static IP routing Between 2 WAN

Actually I am beginer with router. I have cisco 2811 router. I have two FE interface and two Serial interface in my router.

I want route FE1 to S0(WAN1) and FE0 to S1(wan2) respectively. Is it possible? please help me out.

  • LAN Switching and Routing
2 ACCEPTED SOLUTIONS

Accepted Solutions
Bronze

Re: Static IP routing Between 2 WAN

Hi

yes you can do just mark all the traffic comming from Fe1 and Fe0 separately and send it to a specific interface or a destination using route-map command

route-map ....

match access-group acl-101

set ....

HTH

do rate if it clarify

Re: Static IP routing Between 2 WAN

Hi,

you can configure route maps for this.

check out this URL:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1828/products_configuration_guide_chapter09186a00800ca590.html#4553

rate if it helps ....

3 REPLIES
Bronze

Re: Static IP routing Between 2 WAN

Hi

yes you can do just mark all the traffic comming from Fe1 and Fe0 separately and send it to a specific interface or a destination using route-map command

route-map ....

match access-group acl-101

set ....

HTH

do rate if it clarify

Re: Static IP routing Between 2 WAN

Hi,

you can configure route maps for this.

check out this URL:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1828/products_configuration_guide_chapter09186a00800ca590.html#4553

rate if it helps ....

New Member

Re: Static IP routing Between 2 WAN

Yes. Its done. Thank You Very Much

113
Views
0
Helpful
3
Replies
This widget could not be displayed.