Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Static Load Balancing on 3650-X IP Base

Does 3650-X IP Base support Static Load Balancing or i should upgrade to ip service SW ?

4 REPLIES
New Member

Static Load Balancing on 3650-X IP Base

Hi,

I'm not sure, but as I understand Cisco Express Forwarding uses the path information in the IP routing table to balance traffic over multiple links. And not important what you use OSPF, EIGRP or static routes. I suppose IP Base enough for load balancing.

Best regards,

Zak.

VIP Super Bronze

Static Load Balancing on 3650-X IP Base

IP Base image supports static routes.  So, you can have multiple static routes each using a different interface for load balancing.

HTH

New Member

Static Load Balancing on 3650-X IP Base

Thank you jazZz and Reza, but I'm referring to equal cost load balancing via a static route. and according to the link below we need the ip services SW for the dynamic routing LoadBalancing but there is nothing for Static routing LoadBalancing

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps5528/prod_qas09186a00801f3d71.html

cid:image001.png@01CCA9FB.961621A0

So what do u think?

VIP Super Bronze

Static Load Balancing on 3650-X IP Base

Mohamed,

IP services needed if you want to run dynamic routing protocols like OSPF, Full EIGRP, BGP, etc..

Static routes are supported with IP Base, so can deploy mutiple static routes and load balance among them.

HTH

650
Views
0
Helpful
4
Replies
CreatePlease to create content