Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

static nat by destination outside to inside

HI.I'm using Static nat with route-map to translate my server x.x.x.x to y.y.y.y or z.z.z.z depending on the incoming (outside to inside) traffic.

ip nat inside source x.x.x.x y.y.y.y route-map from1-to-y

ip nat inside source x.x.x.x z.z.z.z route-map from2-to-z.

But every incoming traffic to y or z is translating to x whatever the source may be !!!!

even not in acl of the route-map !!!

route map seems to be only there to allow more than one static translation of one source address .

(for outgoing traffic, the route-map works properly)

Can i get some help please.

123
Views
0
Helpful
0
Replies
CreatePlease to create content