Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Static NAT with Source NAT afterwards

Hi folks,

because of overlapping subnets I need to configure 1:1 NAT to a customers VPN site, so far so good.

But my ASA5505 in the customers network isn't the default gateway I have to us Source NAT after it. Now I have the problem that I don't know how to configure 1:1 NAT and Source NAT, any ideas?

Best regards,

Rene

1 REPLY
New Member

Re: Static NAT with Source NAT afterwards

Maybe it's a little bit hard to visualize, so I added a image:

In the 10.1.2.0/24 there are requests with 10.0.1.0/27 as source IP and these packets are routed to the default router, I have no chance to add static routes or somethin to choose the right way back.

If the packets are source-natted with the IP 172.17.1.1 (Interface of the ASA), the way back is correct.

HTH, Rene

323
Views
0
Helpful
1
Replies