Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Static Route question

I am adding some static routes to our core switch.   what I would like to know is if there is a way to label the routes when I put them in.  

I am newer to Cisco so I am still learning.   Here is an example of what we are doing.

typing conf t

#ip route x.x.x.x 255.255.255.0 x.x.x.x  (a label or name here would be nice)

This would be nice so when I run show ip route static I can see what these are for.

Thanks for the help in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Hi

Hi

you can add a name to the static at the end

ip route 1.1.1.1 255.255.255.255 ten 1/1/1 name Marks static

but you wont see it with show ip route but if you run show run | i ip route

You will be able to see them in running config

1 REPLY
VIP Purple

Hi

Hi

you can add a name to the static at the end

ip route 1.1.1.1 255.255.255.255 ten 1/1/1 name Marks static

but you wont see it with show ip route but if you run show run | i ip route

You will be able to see them in running config

31
Views
0
Helpful
1
Replies
CreatePlease to create content