Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Static Routing Problem

I have 2 external connections to two different ISP's. I have implemented load balancing on these interfaces. I need to split up my Lan in two Vlans and want one Vlan passing through load balancing and the other using only a specified ISP. I put only one network IP in the route map and made a separate ip nat inside overload entry for the other vlan, however what is happening is that the packets from the vlan using onlt 1 ISP are still trying to pass and be translated through the route map as there are 2 ip route commands. Basically I have halpf the connectivity as now half the packets are being NAT'd and the other half arent.

Can I route based on source, or perhaps force the interface to route only to a specified next hop and not using the global ip route command?

Thanks

2 REPLIES

Re: Static Routing Problem

can u put the configuration so that we can have a look and then can suggest?

New Member

Re: Static Routing Problem

I solved it using Policy Based Routing.

Thanks for the help.

128
Views
0
Helpful
2
Replies