Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Static RP Configuration PIM vs Candidate RP election

Hi Team,

i have static RP for a group range (225.0.0.0 to 255.0.0.0) and i have configured dynamic RP (bootstrap mechanism) for the same group range.

which one will be elected as RP-SET.

please share your views.

thanks a lot in advance.

regards,

Rajesh kumar V

  • LAN Switching and Routing
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Static RP Configuration PIM vs Candidate RP election

Rajesh

Static RP can co-exist with dynamic RP mechanisms (ie: Auto-RP). Dynamically learned RP takes precedence over manually configured RPs. If a router receives Auto-RP information for a multicast group that has manually configured RP information, then the Auto-RP information will be used.

http://www.cisco.com/c/en/us/products/collateral/ios-nx-os-software/ip-multicast/whitepaper_c11-508498.html

Jon

3 REPLIES
New Member

Static RP Configuration PIM vs Candidate RP election

Any suggestion very much appreciated.

Hall of Fame Super Blue

Static RP Configuration PIM vs Candidate RP election

Rajesh

Static RP can co-exist with dynamic RP mechanisms (ie: Auto-RP). Dynamically learned RP takes precedence over manually configured RPs. If a router receives Auto-RP information for a multicast group that has manually configured RP information, then the Auto-RP information will be used.

http://www.cisco.com/c/en/us/products/collateral/ios-nx-os-software/ip-multicast/whitepaper_c11-508498.html

Jon

New Member

Static RP Configuration PIM vs Candidate RP election

thanks  jon. now i got clarified. thanks agian.

238
Views
0
Helpful
3
Replies