Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

stop process pak for forus packet

Dear all,

We are using a Catalyst 4503 as a core switch of our network and when we check the log we see the following message,

Dec 16 12:02:08: IP: s=178.6.10.1 (Vlan10), d=178.6.10.250, len 132, stop process pak for forus packet

We cannot find any explanation of this message. Can somebody help us to understood what does it means ?

Thanks a lot,

Marc

  • LAN Switching and Routing
1 REPLY
New Member

Re: stop process pak for forus packet

The "forus" packets are packets destined to the router itself and that are usally processed by the RP. In some cases, they might be processed by the LC if you run a distributed architecture platform.

Thanks,

Ahmed

738
Views
0
Helpful
1
Replies
This widget could not be displayed.