03-30-2009 04:27 AM - edited 03-06-2019 04:53 AM
I have a Cat6506 running CatOS with Sup720. The supervisory modules keeps on rebooting (see attachment). How can I break out of this? Thanks in advance.
03-30-2009 05:08 AM
I would call the TAC if it is happening continuosly. It's either a supervisor or memory problem and would probably have to be replaced.
03-30-2009 08:03 AM
There is no break sequence to get into ROMMON?
03-30-2009 02:52 PM
Hi David,
You can go to ROMmon but I doubt if you can do anything to fix the blade.
You need to contact Cisco TAC and get the blade RMA-ed because it has totally (and utterly) failed. Based on the following error messages:
SysAD Parity Error Exception occurred on Mar 30 2009 06:53:22
Nested exception occured
*** Mistral Interrupt on line 2 ***
IO bus interrupt due to illegal addr, no ack, etc
PC = 0xbfc12a04, Cause = 0x1000, Status Reg = 0x30419003
ROM Monitor Can Not Recover From Exception
A Board Reset Is Issued
*** Mistral Interrupt on line 2 ***
Address trap interrupt ..
PC = 0xbfc278bc, Cause = 0x80001000, Status Reg = 0x30419003
ROM Monitor Can Not Recover From Exception
A Board Reset Is Issued
Cat6k-Sup720/SP processor with 524288 Kbytes of main memory
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: