stopping vlan routing on 6509 for one specific vlan.
I want to setup a CUCM lab environment on a seperate vlan but want to take advantage of the POE ports on my 6509. Is there an easy way to create a new vlan but not have it be automatically routed. I don't want any possiblity of the lab CUCM interfering with the production CUCM. In other words I want to create a network that is completely self contained with no access to other vlans on my 6509. I was thinking about using an access list but wanted to get some other opinions to see if that was the best idea.
Re: stopping vlan routing on 6509 for one specific vlan.
Perhaps I'm misunderstanding your question, but if you don't put an IP address on the VLAN interface of the 6509, there is no routing capability. You won't be able to get in or out of the VLAN, but it will prevent that subnet from interacting with other VLANs/subnets.
If you need to get in and out of the VLAN for certain services you could use an ACL like you mentioned or drop a spare firewall in there too. Configure the hosts to use the fw as the gateway and it controls what is permitted up to the 6509.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.