Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

STP Command help

Dear All,

spanning-tree port fast

switch port mode access

is there any command which can combined these two commands.?

means only single command can do the same.

Regards

Toufeeq

1 REPLY
Cisco Employee

STP Command help

Hi,

No and afaik no plans to combine both. Even if both are used usually on a port connected to the end station (host, server, etc) they mean different things. First - not to trigger TCN on port flap and enforce the network boundary. Second only means that all packets should be sent untagged on that port and force traffic to the specific VLAN. Thus nothing in common between two and there are situation you would need access configured without portfast.

Nik

249
Views
0
Helpful
1
Replies