Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

STP - high number of topology changes

RD-CORE-1#sh spanning-tree detail

VLAN0010 is executing the rstp compatible Spanning Tree protocol
  Bridge Identifier has priority 8192, address 00d0.02d5.740a
  Configured hello time 2, max age 20, forward delay 15, tranmsit hold-count 6
  We are the root of the spanning tree
  Topology change flag set, detected flag not set
  Number of topology changes 13589 last change occurred 00:00:33 ago
          from GigabitEthernet3/41
  Times:  hold 1, topology change 35, notification 2
          hello 2, max age 20, forward delay 15
  Timers: hello 0, topology change 1, notification 0, aging 300

I would appreciate any comments on the topology change number in question here.  Is this something I should be concerned about?

2 REPLIES

Re: STP - high number of topology changes

Hi Jason,

TCN comes into picture in switching world when ever there is link up/down has happen in the switching domain,so by default in all cisco swirtches run PVST so if any change or any port goes up/down it will result in TCN and STP convergence for taht particular vlan.

As per the logs in vlan 10 it can happen that any host is getting booted or getting some problem with the switch port which is connected with host getting fluctuated result in TCN and stp convergence for that VLAN 10.

To avoid the TCN frequently portfast is the only feature which can be used in switching before enabling portfast just check out the necessaity check before enabling.

check out below link in understanding of TCN in switching domain hope that helps out your query !!

http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a0080094797.shtml#topic1

Regards

Ganesh.H

Bronze

Re: STP - high number of topology changes

Hello,

I would like to ask you if you can provide me this information.

show version of the switch, also if you can provide me the show run of the unit, and a description of the edge points of your topology in order to confirm what is creating the topology changes.

I will be waiting for your information.

Thanks,

6904
Views
0
Helpful
2
Replies
CreatePlease to create content