And the log: cisco: show spanning-tree vlan 140 VLAN0140 Spanning tree enabled protocol rstp Root ID Priority 140 Address 0015.63c4.ef00 This bridge is the root Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec Bridge ID Priority 140 (priority 0 sys-id-ext 140) Address 0015.63c4.ef00 Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec Aging Time 300 sec
Linksys: show spanning-tree Spanning tree enabled mode RSTP Default port cost method: short Root ID Priority 4096 Address 00:22:6b:bf:f6:eb This switch is the root Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec Times: hold 1, topology change 35, notification 2 hello 2, max age 20, forward delay 15
First at all, sorry for the delay, just have some time to test it again.
You're obviously right.
The option I have:
Cisco:(config)#spanning-tree mode ?
mst Multiple spanning tree mode
pvst Per-Vlan spanning tree mode
rapid-pvst Per-Vlan rapid spanning tree mode
Linksys:(config)# spanning-tree mode
stp Specify IEEE 802.1D Spanning Tree Protocol
rstp Configure IEEE 802.1W Rapid Spanning Tree Protocol
mstp Configure IEEE 802.1S Multiple Spanning Tree Protocol
In the link you send me:
Based on the original IEEE 802.1w standard, RSTP can have multiple VLANs 10, 20, 20 and 40 but will only have a
single instance of spanning tree running for all VLANs, just like the Traditional STP 802.1D (CST). The IEEE 802.1w RSTP standard does not support multiple instances of STP, it does support multiple VLANs. Cisco's version of RSTP, known as RPVST+, combines RSTP with PVST+, and uses a separate instance of spanning tree for each VLAN, just like their proprietary PVST+.
For now, thought I could try the mstp/mst solutions, but I will keep it simple,
so I will try the rapid-pvst/stp solution, and I will comment you.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.