Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

STP

Dear

I have 2 Cisco switch 4006 act as core and distribution layer.

The current spanning tree enable on both of them is pvst mode and they connect to several access switches by 2 fiber optic which is trunk dot1q mode.

I review configuration on access switches but there is no spanning tree enable on some of them and only cost is configured on trunk port.

I need to configure and redesign stp but confuse which one should I select MST or Rapid-PVSTP?

1 REPLY
Purple

Re: STP

I would use pvst+ or Rapid-pvst . Depending on which way your traffic is going make your root for the spanning tree on active side and make root secondary on the non active side .

117
Views
0
Helpful
1
Replies