Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

STP

Hello,

I want to know it's recommanded to put this command:

no spanning-tree optimize bpdu transmission

when we use stp witch pvst mode?

1 REPLY
Bronze

Re: STP

The purpose of the 'no spanning-tree optimize bpdu transmission' command is to avoid bpdu transmission from being optimized. If the bpdu transmission were to be optimized on the 2950 platform, it could potentially consume too much CPU utilization and have an impact on other software features that may be simultaneously configured on the switch. Going forward, there are no plans to change the default behavior of this command. Also, there is no way to disable this command.

106
Views
0
Helpful
1
Replies