03-05-2008 11:39 PM - edited 03-05-2019 09:34 PM
Hi,
How we can convert the port into blocking or listening or root port with the help of Stp? please give replay for this doubt.
thanks
Sham
03-06-2008 12:57 PM
Hi Sham,
There are several parameters that can be configured in STP that will determine the state of ports in the final stable spanning tree:
1. Switch priority: by configuring this value, you can control the selection of the root switch, which will partly influence which ports can be root ports on other switches.
2. Port cost: this will influence the selection of root ports, designated ports and blocked ports.
3. Port priority: this can also influence the selection of root ports, designated ports or blocked ports, when no other tie-breaking value is present.
There can be 100 pages written about this, depending on the level of detail one intends to write.
If you come up with a specific configuration, then I can help you sort out your configuration and control the port states.
Cheers:
Istvan
03-07-2008 01:55 AM
Hi,
How we can define the port cost and port priority,in a switch which is the command used for configuring this?
Regards,
Sham.
03-07-2008 09:24 AM
Hi Sham,
Both parameters have to be defined in interface configuration mode.
Port cost (1 to 65535):
spanning-tree cost xx
This will modify the port cost for all vlans.
spanning-tree vlan x cost yy
This will modify the port cost for vlan x.
Port priority (0 to 255):
spanning-tree port-priority xx
This will modify the port priority for all vlans.
spanning-tree vlan x port-priority yy
This will modify the port priority for vlan x.
Cheers:
Istvan
03-06-2008 03:09 PM
Hi,
Have a look at this guide, it will take you through all necessary options
HTH
Shaheen
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: