Did the switch crash ? or did you reboot the switch since you had any issues ? do you have any crashinfo files generated when the switch rebooted ? This looks a new error when compared with the existing %c4k messages... do you have support contract for this switch ? If so you can raise a tac since this is a new error message.... I ran output interpretor but didnt get any response for this message..
thanks.. I opened a TAC for this issue.. and come to know that it is a parity error which is related to hardware issue. as per tac there are 2 types of parity error, one is hard and other soft paraty error.. if it heppen once then it is soft parity error and we can continue with existing switch.. but if heppen again which can be considered as hard parity error then we need to raise RMA for sup... in case of hard parity error the incident will reoccur and frequency of incident increases.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.