Stuck at the Initial stage CISCO pix 515e

[srikanth ath]

Stuck at Initial stage CISCO pix 515e

Hi

I have a new pix 515e for Home pratice.

1. I couldnt telnet the switch after configuring. should i have to use cross cable or not to connect PC-PIX? (as new switches and routers run through straight cable). more importantly i couldnt even ping the inside ip which is telnet and ssh enabled.

2.  Recieveing the following after executing each and every command on global mode.

******warning****

configuration Replication is NOT performed From standby Unit to Active Unit

configurations are no longer synchronized.

Hope you guys pull me out from these issues

Thanks & Regards

srikanth

[cadet alain]

Hi,

If you could leave one only one thread for your problem and in the Firewall section of security you already did,it would be simpler for everybody to help.

Alain.

[srikanth ath]

http://www.cisco.com/en/US/docs/security/pix/pix63/command/reference/s.html#wp1026535