Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

sub-50ms protection switching at Ethernet layer (ERPS G.8032 ITU-TG)

Hi,

It is understood that sub-50 ms ERPS convergence can be achieved with certain HW/SW combinations.

1) What are the platforms supported (and with what FW/SW) has this been tested ?any results that can be shared?

2)  Link failure detection in GigE on Copper is slower compared to GigE  over "pure" Fibre; so no sub-50ms would be possible with Copper ring ports.

is sub-50ms convergence achievable with "combo SFP ports" ?

appreciate your thoughts, experience on this.

535
Views
0
Helpful
0
Replies
CreatePlease to create content