Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Sub-Int and Encapsulation

Hi!

I have the following routers ...

2650 and two 2620s running c2600-i-mz.123-26.bin. THe problem is that when I create a sub-interface the option for encapsulation is not there. If I am not mistaken, the IOS is the most current release for the routers for IP services and is advertised by cisco to work for both routers. Is it not a part of that IOS or is this caused by something else?

2650 - http://tools.cisco.com/support/downloads/go/ImageList.x?relVer=12.3.26&mdfid=268437953&sftType=IOS+Software&optPlat=&nodecount=2&edesignator=GD&modelName=Cisco+2650+Multiservice+Platform&treeMdfId=268437899&treeName=Routers&modifmdfid=null&imname=&hy...

2620 - http://tools.cisco.com/support/downloads/go/ImageList.x?relVer=12.3.26&mdfid=268437951&sftType=IOS+Software&optPlat=&nodecount=2&edesignator=GD&modelName=Cisco+2620+Multiservice+Platform&treeMdfId=268437899&treeName=Routers&modifmdfid=null&imname=&hy...

Thanks in advance,

Richard

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: Sub-Int and Encapsulation

Richard

You have the wrong feature set. You need a minimum of IP PLUS to support 802.1q encapsulation - see this link (table 2)

http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a00800949fd.shtml

c2600-i-mz.123-26.bin = IP

c2600-is-mz.123-26.bin = IP Plus

Upgrade to IP Plus and the encapsulation command will be available.

Jon

3 REPLIES
Hall of Fame Super Blue

Re: Sub-Int and Encapsulation

Richard

You have the wrong feature set. You need a minimum of IP PLUS to support 802.1q encapsulation - see this link (table 2)

http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a00800949fd.shtml

c2600-i-mz.123-26.bin = IP

c2600-is-mz.123-26.bin = IP Plus

Upgrade to IP Plus and the encapsulation command will be available.

Jon

New Member

Re: Sub-Int and Encapsulation

Hi Richard, I read your posting and was courious about encapsulation on a sub-interface. I checked one of my routers and I also am unable to configurer encapsulation on this sub-interface but it is available on the primary interface, eager to see what the reason for this is also.

Donald

New Member

Re: Sub-Int and Encapsulation

Donald ... see Jon's reply above. It is correct.

Richard

131
Views
0
Helpful
3
Replies
CreatePlease to create content