I have some 2600 routers that do not allow for encapsulation to be set when a sub-interface is created. I guess this is due to IOS but was wondering how you configure a sub-interface without the encap command available. I imagine it is a possibility since it allows for the creation of the sub-if but can't figure out how. Is it done by using the bridge group commands?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...