cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
273
Views
0
Helpful
2
Replies

Sub-interface routing

robert-knapp
Level 1
Level 1

Will a 2811 running 12.4(11)X/Advanced-Enterprise-Services route between sub interfaces?

I can't get traffic from f0/0.50 to route to f0/0.100. Both interfaces have IPs and are doing dot1q trunking.

Traffic from both these interface can route to f0/1.

2 Replies 2

glen.grant
VIP Alumni
VIP Alumni

Can you post the interface config , probably something with that . It should route fine between subinterfaces , probably the trunk isn't setup correctly between the router and switch. If possible post the switch config also.

It works now. I had to enable NAT on one of the interfaces. thanks.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: