Hello everyone -- I read over the chart for support of the 16-port 10G module for the 6500-E chassis, but I'm having issues completely understanding the matrix and what's required to support it. We've got dual SUP-720-3B modules with PFC3 daughter cards, which looks like it's supported, but I was hoping someone has done this and can confirm it is accurate, and any caveats or gotchas that people have come across.
The 16-port 10 Gigabit Ethernet module is interoperable with all models of the Cisco Catalyst 6500 Series Virtual Switching Supervisor Engine 720 with 10 Gigabit Ethernet uplinks or Cisco Catalyst 6500 Series Supervisor Engine 720, including VS-S720-10G-3C, VS-S720-10G-3CXL, WS-Sup720, WS-Sup720-3B, and WS-Sup720-3BXL. When mixing DFCs in the same chassis, the chassis will operate in the mode of the lowest common denominator.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...