Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Sup 720 HA redundnacy

with the new msfc3 and IOS vers 12.2.18, does anybody know what best method for redundancy is now: SSO or RPR + ??

Regards

Brannon Lamoureux

3 REPLIES
Cisco Employee

Re: Sup 720 HA redundnacy

Hi Brannon,

SSO is always better then RPR+ if you IOS supports the same because the switchover time with SSO is less then 3 seconds where in RPR+ it is approx 30 seconds.

SSO needs minimum 12.2(18)SXD and as you mentioned you have 12.218 release I will recommed you to opt for NSF with SSO.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a008027e4cd.html

HTH

Ankur

*Pls rate all helpfull post

Cisco Employee

Re: Sup 720 HA redundnacy

Brannon,

SRM is the good option rather than RPR+ as RPR+ gives you the switchover arnd 30-60 seconds while SSO gives you subsecond failover with 0-3 seconds.

Starting with IOS 12.2.18 code we default to SSO. RPR+ was used prior to the 12.2.18 Code. Use SSO/NSF for L2/L3 HA. Prior to 12.2.18 code we were supporting SSO/SRM

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/swcg/nsfsso.htm

HTH,Please rate if it does.

-amit singh

New Member

Re: Sup 720 HA redundnacy

How does SSO/NSF work with MPLS LDP, I am testing and have an MPLS network I do not get 0 - 3 seconds repair time, it is about ~30 Sec same as RPR+

tx

143
Views
0
Helpful
3
Replies