cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
256
Views
0
Helpful
1
Replies

Sup 720 status LED

gautamzone
Level 1
Level 1

Hi friends,

There was a power down in the data center and after it was up, the status LED on the 720 sup showed the following:

1. On the first 6513 switch, Port 2 UTP link led showed amber for both active and standby supervisors.Nothing was connected to those ports.

2. On the second 6513 switch, Port

Port 1 and Port 2 link LED's showed amber for both active and standby supervisors. Nothing was connected to those ports.

Right now, everything is normal, but do these ambers indicate any problem.

Thanks a lot

Gautam

1 Reply 1

Hi,

In according with http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a0080395a21.html the link is orange when "the link has been disabled by software".

You could try this: enable ports with no shutdown.

I hope this helps.

Best regards.

Massimiliano.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: