Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

SUP Failover testing

Please help me with the procedure for Soft SUP Failover testing:

sw1#show redundancy

Redundant System Information :

------------------------------

Available system uptime = 7 weeks, 3 days, 13 hours, 20 minutes

Switchovers system experienced = 4

Standby failures = 0

Last switchover reason = user forced

Hardware Mode = Duplex

Configured Redundancy Mode = Stateful Switchover

Operating Redundancy Mode = Stateful Switchover

Maintenance Mode = Disabled

Communications = Up

Current Processor Information :

-------------------------------

Active Location = slot 1

Current Software state = ACTIVE

Uptime in current state = 1 week, 5 days, 14 hours, 24 minutes

Image Version = Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-ENTSERVICESK9-M), Version 12.2(53)SG2, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2010 by Cisco Systems, Inc.

Compiled Mon 15-Mar-10 23:32 by prod_rel_team

BOOT = bootflash:cat4500-entservicesk9-mz.122-53.SG2.bin,1;device:cat4500-entservicesk9-mz.122-53.SG2.bin,1;

Configuration register = 0x2102

Peer Processor Information :

----------------------------

Standby Location = slot 2

Current Software state = STANDBY HOT

Uptime in current state = 1 week, 5 days, 14 hours, 20 minutes

Image Version = Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-ENTSERVICESK9-M), Version 12.2(53)SG2, RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2010 by Cisco Systems, Inc.

Compiled Mon 15-Mar-10 23:32 by

BOOT = bootflash:cat4500-entservicesk9-mz.122-53.SG2.bin,1;device:cat4500-entservicesk9-mz.122-53.SG2.bin,1;

Configuration register = 0x2102

sw1(config)#redundancy ?

<cr>

sw1(config)#

1 REPLY

SUP Failover testing

From the exec prompt, you can do:

redundancy force-switchover

John

HTH, John *** Please rate all useful posts ***
209
Views
0
Helpful
1
Replies
CreatePlease to create content