Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SUP Sync

Hi,

I have the switch running with single SUP And the 2nd SUP is faulty. I got a new SUP from CISCO. However, the new SUP is having different ISO as compare to the existing SUP. Now I want sync the configuration & configure SUP as backup to other. Please advice me how to go forward.

Thanks!!

2 REPLIES
Silver

Re: SUP Sync

What is the platform, 6500 or 4500?

what is the file system of the active sup, bootflash:, disk0: or bootdisk:

You can do a dir slavebootflash: for example to confirm you have access to the standby sup and then you can copy the IOS from the active to the standby, do a write mem and reload the standby sup to it loads the same IOS as the active + the config file

New Member

Re: SUP Sync

Hi,

It's 6500 & having CATOS.

I tried to access slavebootflash:, but no luck

Switch> (enable) dir slavebootflash:

Open device slavebootflash failed (unknown device)

Switch> (enable)

Also, fyi pls

Mod Hw Fw Sw

--- -------------------------------------- ------ ---------- -----------------

1 3.2 5.3(1) 5.4(4)

15 1.1 12.1(8b)E7 12.1(8b)E7

2 7.0 5.3(1) 6.4(9)

16 1.1 12.1(8b)E1 12.1(8b)E15

SUP in slot is the one I got from Cisco in RMA. They are having different Hw, Fw, Sw versions.

Pls advice. Thanks!!

240
Views
0
Helpful
2
Replies