cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
331
Views
0
Helpful
4
Replies

SUP2 - "MEM-S2-512MB" not recognized

brobinson
Level 1
Level 1

ALOHA -

When recently installed a "MEM-S2-512MB" in our SUP2 in the 6500 and it does not recognize it. Still says there is 128 MB. Followed the directions to install the chip and it's in there now, but still shows 128 MB. Please advise.

4 Replies 4

1) Did you place the 512MB on the same slot as the older 128MB was or is this on a different DIMM slot?

2) Are you sure that the DIMMs are placed properly?

Yup, we swapped the old one out, and they are seated.

Thanks for the quick reply!

Can you try the following?

1) Put the RAM on other DIMM slot and power it on. (Hope you didnt pull the SUP when it chassis was "ON")

2) Swap the RAM again to the original one.

Could you please talk to the cisco vendor from whom you bought this RAM if there are any issues.

You need to open a TAC case.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco