Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Sup2T ##show platform qos ## command

Hi everyone,

The white paper about sup2t System Architecture

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/white_paper_c11-652042.html#wp9000594

says:

By default, packets are passed through without a change in DSCP, EXP, or CoS for L2 packets or L2-classified L3 packets

However, when I see the output of the command "show platform qos" there are " CoS Changes"

----- Switch [1], Module [1] -----

                 Counter   IFE Pkts     IFE Bytes    OFE Pkts     OFE Bytes

---------------------------------------------------------------------------

          Policing Drops 0              0              0          0          

       Policing Forwards 1136306595     26171591950357  1150627829 26173991946454

Police-hi Actions (Lvl3) 0              0              0          0          

Police-lo Actions (Lvl2) 0              0              0          0          

         Aggregate Drops 0              0              0          0          

      Aggregate Forwards 1136306593     26171591950221  1150627827 26173991946318

    Aggregate Exceeds-Hi 0              0              0          0          

    Aggregate Exceeds-Lo 0              0              0          0          

                NF Drops 0              0              0          0          

             NF Forwards 2              136            2          136        

              NF Exceeds 0              0              0          0          

                                       TOS Changes 1           

                                        TC Changes 0           

                                       EXP Changes 0           

                                       COS Changes 949932      

                                     Tunnel Decaps 1           

                                     Tunnel Encaps 1  

1. ¿Why there are cos changes?

2. ¿What are Policing Forwards and Aggregate Forwards?

I have two C6500E (Sup2T Supervisor) in VSS mode and my config is quite similar to defaults.

auto qos default

table-map cos-discard-class-map

map from  5 to 46

interface Port-channel10

switchport

platform qos trust cos

interface GigabitEthernet1/1/6

switchport

platform qos trust cos

channel-group 10 mode active

3. ¿Could it be related to CoPP?

Thank you in advance.

166
Views
0
Helpful
0
Replies
CreatePlease to create content