I have deployed 2 catalyst 6500 with 2x sup32 for each cat, I try to connect both switch?s by two 10G interfaces on each chassis (one in the standby and one in the active) but with no look, the only 10G interfaces that came up was the 10G interface from the standby sup32, the 10G from the active sup did not appear in the show run.
Is this beaver normal, can I use the 10G interfaces from both redundant/standby sup32 ?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...