Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Sup720-10G ASICs

Interested to know what the command is that will show the ASIC

to port mapping on the 6500? I want to assess the impact of QoS changes on some ports, and how those changes

will get propagated to other ports on the same ASIC.

2 REPLIES
Hall of Fame Super Blue

Re: Sup720-10G ASICs

dasmith wrote:

Interested to know what the command is that will show the ASIC

to port mapping on the 6500? I want to assess the impact of QoS changes on some ports, and how those changes

will get propagated to other ports on the same ASIC.

Don't know the command but you can use the release notes for this, just go to the module you are interested in and it lists the port groups/port ranges -

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SXF/native/release/notes/OL_4164.html

Jon

Hall of Fame Super Bronze

Re: Sup720-10G ASICs

Router> show interfaces capabilities module 6 

FastEthernet6/1 
Dot1x: yes 
Model: WS-X6248-RJ-45 
Type: 10/100BaseTX 
Speed: 10,100,auto 
Duplex: half,full 
Trunk encap. type: 802.1Q,ISL 
Trunk mode: on,off,desirable,nonegotiate 
Channel: yes 
Broadcast suppression: percentage(0-100) 
Flowcontrol: rx-(off,on),tx-(none) 
Membership: static 
Fast Start: yes 
QOS scheduling: rx-(1q4t), tx-(2q2t) 
CoS rewrite: yes 
ToS rewrite: yes 
Inline power: no 
SPAN: source/destination 
UDLD yes 
Link Debounce: yes 
Link Debounce Time: no 
Ports on ASIC: 1-12 
Port-Security: yes 

1013
Views
0
Helpful
2
Replies
CreatePlease to create content