Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

sup729 SSO redundancy, ether channel automatic?

Regarding Failover/ Port channel with 2 6513s each unit running dual sup720 3B, Question with Sup720 3Bs (PFC-3B) running SSO redundacny do I have to configure ether channel? or can I go ahead and just patch between both 6513 supervisors to utilize all gig ports, since SSO is already configured, does SSO take care of ether channelling? do I have to configure port channel on top of SSO to get port/ether channel?

1 REPLY

Re: sup729 SSO redundancy, ether channel automatic?

If I understand your question right you will need to create an etherchannel between the 6513's. All SSO does is create supervisor redundancy between the supervisors in the local chassis. SSO does not take care of etherchanneling and must be configured to work.

Mark

127
Views
0
Helpful
1
Replies
CreatePlease to create content