Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Sup7L-E - How to select "1-Gigabit Operation"?

Documentation discusses "1-Gigabit Operation", where all 4 1-Gig SFP's on Sup7L-E are enabled.   But it does not say __how__ to select either 10-G or 1-G operational modes. 

Please help!   I have searched & searched, & cannot find any mention of how to do this.

thanks in advance....

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Sup7L-E - How to select "1-Gigabit Operation"?

Hello Lorraine,

From the release notes

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/release/note/OL_25346.html#wp2552887

" Supervisor  Engine 7L-E has two modes (One-Gigabit and Ten-Gigabit), which can be  changed from Ten-Gigabit to One-Gigabit, or One-Gigabit to 10-Gigabit by  entering the hw-module uplink select [gigabitethernet | tengigabitethernet] command and then reloading the shelf . By default, Supervisor Engine 7L-E is in Ten-Gigabit mode"

Also :

"Supervisor Engine 7L-E supports two Ten-Gigabit  ports in Ten-Gigabit mode and four One-Gigabit ports in One Gigabit mode  non blocking. SFP+ transceivers are not be supported in 1 Gigabit mode."

Best regards.

Karim

3 REPLIES
New Member

Sup7L-E - How to select "1-Gigabit Operation"?

finally found it. 

Syntax is,

conf t

hw-module uplink select gigabitethernet

end

msg is generated:

"A reload o fthe active supervisor is required to apply the new configuration." 

Silver

Sup7L-E - How to select "1-Gigabit Operation"?

Hello Lorraine,

From the release notes

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/release/note/OL_25346.html#wp2552887

" Supervisor  Engine 7L-E has two modes (One-Gigabit and Ten-Gigabit), which can be  changed from Ten-Gigabit to One-Gigabit, or One-Gigabit to 10-Gigabit by  entering the hw-module uplink select [gigabitethernet | tengigabitethernet] command and then reloading the shelf . By default, Supervisor Engine 7L-E is in Ten-Gigabit mode"

Also :

"Supervisor Engine 7L-E supports two Ten-Gigabit  ports in Ten-Gigabit mode and four One-Gigabit ports in One Gigabit mode  non blocking. SFP+ transceivers are not be supported in 1 Gigabit mode."

Best regards.

Karim

New Member

Sup7L-E - How to select "1-Gigabit Operation"?

I had found the answer, only one minute before you replied  -   but I appreciate your response, all the same! 

thanks, and have a nice weekend   

1181
Views
0
Helpful
3
Replies
CreatePlease to create content