Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

SUP7L-E IOS XE - QoS Service Policy input

Hello,

we're implementing MQC on Cat4500 SUP7L-E with service policy input and output (marking, classification, traffic shaping with BW limitation) on Gigabit ports towards users.

On the switch ports the service-policy output is working fine limiting the traffic BW correctly for the class DATA and the other, but the service-policy input is not working since it does not limit the traffic BW...below is a generic sample of config implemented.

Am I missing something sicne it should be supported on this platform both in input and output?

ip access-list extended VOIP_IN

permit ip subnetVoIP1 subnetPBX01

permit ip subnetVoIP1 subnetPBX02

permit ip subnetVoIP1 subnetVoIP2

!

ip access-list extended DATA_IN

permit ip subnetDATA1 any

!

class-map match-all CLASS-VOIP-IN

  match access-group name VOIP_IN

!

class-map match-all CLASS-DATA-IN

  match access-group name DATA_IN

!

policy-map POLICY-TRAFFIC-IN

  class CLASS-VOIP-IN

   set dscp ef

   police 5m conform-action transmit exceed-action transmit

  class CLASS-DATA-IN

   set dscp 0

   police 30m conform-action transmit exceed-action drop

!

interface g X/Y

service-policy input POLICY-TRAFFIC-IN

If I check the ACL DATA_IN for the service-policy input I don't see traffic matching...but if i check the ACL DATA_OUT (which is configured as opposite) I see traffic that has matched and it works limiting the bandwidth for DATA to 30m...this is not happening for the input

Thanks for suggestions and tips

OG

240
Views
0
Helpful
0
Replies
CreatePlease to create content