First of all you have to enable the shread-backplane to have the 10GE ports active on both the supervisor engines. This is to make sure that you have either all the 10GE interfaces or 1GE interfaces active on both the sup's. The command to do this is :
One question and the last one, in mode redundancy SSO, how many seconds take in the event that the active supervisor engine fails, the redundant supervisor engine becomes the new active supervisor engine?????
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.