Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

supervisor engine error

Hello,

On an existing 4500 switch with a single sup 6-E, another sup 6-E is added. But the second sup6-E comes up as synchronised with active and in a few minutes time, reloads again. the software is 12.2(44) is the same on both sup engines. the redundancy sso output shows that slot6 is disabled.

Please help.

1 REPLY
Community Member

supervisor engine error

post logs please.and

sh module

sh ver

226
Views
0
Helpful
1
Replies
CreatePlease to create content