Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Supervisor Engine II-Plus-10GE usage

Here is somebody can tell me how to use the Supervisor Engine II-Plus-10GE usage on a c4506.

it is necesary to use a https link or an other method. Do you have a HOW TO ?

thanks

1 REPLY
Hall of Fame Super Silver

Re: Supervisor Engine II-Plus-10GE usage

Hello Olivier,

do you mean how to configure and how to access the device?

if it is new you should try to setup a console connection to the console port of the supervisor.

You need to use the console cable that is provided with it with an RJ-45 end and a DB-9 connector to be placed in the RS-232 of your PC.

After an initial configuration on the console you can then telnet to the switch.

Edit:

a GUI environment for C4500 exists named Cisco Network Assistant and its usage is described here:

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/46sg/configuration/guide/netasist.html

Edit2:

I've seen in your other thread that you have already setup your C4500 for CNA access: so forgive my notes in this post they are useless for you.

I can tell you I never used it.

Hope to help

Giuseppe

125
Views
0
Helpful
1
Replies