Supervisor Engine II-Plus and WS-X4612-SFP-E compatibility
I recently bought a
WS-X4612-SFP-E line card to increase our fiber port density on a 4506-E switch but it fails to show in inventory nor do the status led come on. We use Supervisor engine II-plus, I was wondering if this engine supports the card since I couldn't find any doc that shows which line cards the sup II-plus suports
Output of sh version:
Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-IPBASE-M), Version
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...