Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

supervisor engine redundandy Cat 6509 (active module)

Hi everybody:

I have two catalyst 6509 with supervisor engine redundandy; first one has the module 5 active and the second has the module 6 active.

Is there a way to change configuration to set wich module will be active? I want to configure the same module active in both boxes.

Thank you for your comments.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: supervisor engine redundandy Cat 6509 (active module)

Whichever Supervisor boots up first will be the active one. There isn't a command to specify a priority for this.

With that say, you can manually force a switchover if you want the current standby Supervisor as active.

HTH,

__

Edison.

1 REPLY
Hall of Fame Super Bronze

Re: supervisor engine redundandy Cat 6509 (active module)

Whichever Supervisor boots up first will be the active one. There isn't a command to specify a priority for this.

With that say, you can manually force a switchover if you want the current standby Supervisor as active.

HTH,

__

Edison.

330
Views
0
Helpful
1
Replies
CreatePlease to create content