I need to replace a dozen SUP1A's running CatOs with WS-X6K-S2-PFC2's and copy the configs over.
I don't think I can just put a Sup2 into slot 2 and have the configs sync with the active Sup 1A in slot 1 because the hardware is different, right ?
I have a spare 6509 chassis I can use to build the WS-X6K-S2-PFC2's one at a time, cut and paste in the configs, and then swap the 2's with the production 1A's, but is there a better way to accomplish what I'm trying to do ?
Any advice or experience you can share would be very greatly appreciated.
Yes you are right sup 1a and sup 2 are different hardware so both cannot reside at a same time in single chassis and will not synch the config.
The best way will be to use a seperate chassis as you mentioned and make one sup 2 ready and then replace sup 1a and insert sup 2. Once sup 2 is active then you can keep inserting other sup 2s in same chassis in standby slot and can get the config synched.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...