Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Supervisor restart after flapping interface put in err-disable

From what i can tell CR01's active supervisor restarted itself right after CR02's side of the link began flapping and was placed into err-disable to stop the flapping.

What i am trying to figure out is why did the Sup restart itself, and how can this be mitigated in the future?

Attached are the logs from both Devices (6509's) around the time that the issue happened.

Thank you for your help.

1 REPLY
Cisco Employee

Re: Supervisor restart after flapping interface put in err-disab

Can you provide the crashinfo files for CR01? There should be two files. By default the RP crashinfo will be in slavebootflash: and the SP will be in slavesup-bootflash:

I don't see anything in the logs which would point to the cause.

580
Views
0
Helpful
1
Replies