Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Switch 2960 Ports are blink with Amber & green lights without port down

hi

Case 1

---------

I have some queries on Port ligth indication on Switch 2960 . I have connected on port 0/48 & 0/49 Firewall( Check Point) IN & OUT interface ,both the ports are up and working , but when seen at ports lights its continuously blink amber & green and when seen on Switch Logging port is also not flapping or going down ..

Command at Both 0/48 & 0/47 are

switchport mode access

switchport access vlan XYZ

spanning-tree portfast enable.

pls suggest on this

Case 2

-------

On same switches I have connnected the unmanaged Third Party Switches Uplink in Access mode , its also working but on that port also I am getting same port blink indication , but port is not going down

Regrds

Sachin

4 REPLIES
New Member

Re: Switch 2960 Ports are blink with Amber & green lights withou

From the configuration which u have given,

this could be a problem due to bpduguard not being enabled.

New Member

Re: Switch 2960 Ports are blink with Amber & green lights withou

hi thanks

I do have enable and tested on the network but since the client have more than 50 unmanaged switches in netwoork and at DC I am using only Three Cisco 2960 Access Switches with Core 3750 , with BPDUGruad Enable on accessport affects the ping response in local lan , but if I remove the Bpduguard its work fine .... should i use bpduguard filter on interface

Regrds

Sachin

Silver

Re: Switch 2960 Ports are blink with Amber & green lights withou

check for collisions/errors. sho interface...

New Member

Re: Switch 2960 Ports are blink with Amber & green lights withou

Sounds to me like a port duplex miss-match. try hard setting the duplex on both ends.

9916
Views
0
Helpful
4
Replies