Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Switch 2960-S

Good evening,

I have purchased a new 2960 - S switch catalyst and have configured one SVI (interface -Layer 3). But my problem is that can't to use the show ip route command on this model.

 

This device has the universalk9 flash.

 

Thanks in advance!

http://networkingcontrol.wordpress.com/ #CCNP CSCO11962956
1 REPLY
New Member

You won't be able to, because

You won't be able to, because it's a L2 switch, i.e. it cannot route!

 

Martin

59
Views
0
Helpful
1
Replies