Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Switch always going off every 2days

Hello All,

I have a switch that goes of every two days on our network.. Please see sh logging details after a reboot was perform.

can anyone tell me what the issue might be

Note: this switch is connected to a Video Conference device

 

 

 

 

See show logging details i get on 

 

Syslog logging: enabled (0 messages dropped, 0 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled)

No Active Message Discriminator.

 

No Inactive Message Discriminator.


    Console logging: level debugging, 30 messages logged, xml disabled,
                     filtering disabled
    Monitor logging: level debugging, 0 messages logged, xml disabled,
                     filtering disabled
    Buffer logging:  level debugging, 30 messages logged, xml disabled,
                     filtering disabled
    Exception Logging: size (4096 bytes)
    Count and timestamp logging messages: disabled
    File logging: disabled
    Persistent logging: disabled

No active filter modules.

    Trap logging: level notifications, 26 message lines logged
        Logging to 155.236.224.133  (udp port 514,  audit disabled,
              authentication disabled, encryption disabled, link up),
              26 message lines logged,
              0 message lines rate-limited,
              0 message lines dropped-by-MD,
              xml disabled, sequence number disabled
              filtering disabled
        Logging to 155.236.240.190  (udp port 514,  audit disabled,
              authentication disabled, encryption disabled, link up),
              26 message lines logged,
              0 message lines rate-limited,
              0 message lines dropped-by-MD,
              xml disabled, sequence number disabled
              filtering disabled
        Logging to 155.236.239.16  (udp port 514,  audit disabled,
              authentication disabled, encryption disabled, link up),
              26 message lines logged,
              0 message lines rate-limited,
              0 message lines dropped-by-MD,
              xml disabled, sequence number disabled
              filtering disabled
        Logging to 155.236.239.17  (udp port 514,  audit disabled,
              authentication disabled, encryption disabled, link up),
              26 message lines logged,
              0 message lines rate-limited,
              0 message lines dropped-by-MD,
              xml disabled, sequence number disabled
              filtering disabled
        Logging to 10.2.18.22  (udp port 514,  audit disabled,
              authentication disabled, encryption disabled, link up),
              26 message lines logged,
              0 message lines rate-limited,
              0 message lines dropped-by-MD,
              xml disabled, sequence number disabled
              filtering disabled

Log Buffer (4096 bytes):

*Mar  1 00:00:36.574: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down
*Mar  1 00:00:37.908: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlan
*Mar  1 00:00:40: %SYS-6-CLOCKUPDATE: System clock has been updated from 00:00:40 UTC Mon Mar 1 1993 to 01:00:40 GMT+1 Mon Mar 1 1993, configured from console by console.
*Mar  1 00:00:44: %SW_VLAN-6-VTP_DOMAIN_NAME_CHG: VTP domain name changed to unite-phc.
*Mar  1 00:00:44: %SYS-5-CONFIG_I: Configured from memory by console
*Mar  1 00:00:44: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan12, changed state to down
*Mar  1 00:00:45: %SYS-5-RESTART: System restarted --
Cisco IOS Software, C3560 Software (C3560-IPSERVICESK9-M), Version 12.2(52)SE, RELEASE SOFTWARE (fc3)
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Fri 25-Sep-09 08:13 by sasyamal
*Mar  1 00:00:45: %SNMP-5-COLDSTART: SNMP agent on host PHO-LAN-HEL-A-SW01 is undergoing a cold start
*Mar  1 00:00:45: %SSH-5-ENABLED: SSH 2.0 has been enabled
*Mar  1 00:00:45: %SYS-6-LOGGINGHOST_STARTSTOP: Logging to host 155.236.224.133 Port 514 started - CLI initiated
*Mar  1 00:00:45: %SYS-6-LOGGINGHOST_STARTSTOP: Logging to host 155.236.240.190 Port 514 started - CLI initiated
*Mar  1 00:00:45: %SYS-6-LOGGINGHOST_STARTSTOP: Logging to host 155.236.239.16 Port 514 started - CLI initiated
*Mar  1 00:00:45: %SYS-6-LOGGINGHOST_STARTSTOP: Logging to host 155.236.239.17 Port 514 started - CLI initiated
*Mar  1 00:00:45: %SYS-6-LOGGINGHOST_STARTSTOP: Logging to host 10.2.18.22 Port 514 started - CLI initiated
*Mar  1 00:00:46: %LINK-3-UPDOWN: Interface FastEthernet0/18, changed state to up
*Mar  1 00:00:46: %LINK-3-UPDOWN: Interface FastEthernet0/19, changed state to up
*Mar  1 00:00:46: %LINK-3-UPDOWN: Interface FastEthernet0/20, changed state to up
*Mar  1 00:00:46: %LINK-3-UPDOWN: Interface FastEthernet0/22, changed state to up
*Mar  1 00:00:47: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/18, changed state to up
*Mar  1 00:00:47: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/19, changed state to up
*Mar  1 00:00:47: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/20, changed state to up
*Mar  1 00:00:47: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/22, changed state to up
*Mar  1 00:00:47: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/23, changed state to up
*Mar  1 00:00:48: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to up
*Mar  1 00:00:48: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan12, changed state to up
*Mar  1 00:00:48: %LINK-3-UPDOWN: Interface FastEthernet0/23, changed state to up
*Mar  1 00:00:51: %LINK-3-UPDOWN: Interface FastEthernet0/10, changed state to up
*Mar  1 00:00:52: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/10, changed state to up
Oct 15 08:21:29: %SYS-5-CONFIG_I: Configured from console by opeoluwa on vty0 (10.155.169.156)
Oct 15 08:23:42: %SYS-5-CONFIG_I: Configured from console by opeoluwa on vty0 (10.155.169.156)
PHO-LAN-HEL-A-SW01#

5 REPLIES
Hall of Fame Super Gold

Post the "sh version" output.

Post the "sh version" output.

New Member

Hello Leo see ''sh version''

Hello Leo see ''sh version'' output

 

=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2014.10.15 11:34:50 =~=~=~=~=~=~=~=~=~=~=~=
sh ver
Cisco IOS Software, C3560 Software (C3560-IPSERVICESK9-M), Version 12.2(52)SE, RELEASE SOFTWARE (fc3)
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Fri 25-Sep-09 08:13 by sasyamal
Image text-base: 0x01000000, data-base: 0x02E00000

ROM: Bootstrap program is C3560 boot loader
BOOTLDR: C3560 Boot Loader (C3560-HBOOT-M) Version 12.2(44)SE5, RELEASE SOFTWARE (fc1)

PHO-LAN-HEL-A-SW01 uptime is 2 hours, 24 minutes
System returned to ROM by power-on
System restarted at 09:09:59 GMT+1 Wed Oct 15 2014
System image file is "flash:c3560-ipservicesk9-mz[2].122-52.SE.bin"


This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
 --More--         to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to
export@cisco.com.

cisco WS-C3560-24PS (PowerPC405) processor (revision U0) with 131072K bytes of memory.
Processor board ID FDO1324X34F
Last reset from power-on
2 Virtual Ethernet interfaces
24 FastEthernet interfaces
2 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.

512K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address       : 00:26:51:6E:31:80
Motherboard assembly number     : 73-9673-13
Power supply part number        : 341-0029-05
Motherboard serial number       : FDO132506JD
Power supply serial number      : DTN13214451
 --More--         Model revision number           : U0
Motherboard revision number     : A0
Model number                    : WS-C3560-24PS-S
System serial number            : FDO1324X34F
Top Assembly Part Number        : 800-25861-07
Top Assembly Revision Number    : A0
Version ID                      : V09
CLEI Code Number                : COMFJ00BRA
Hardware Board Revision Number  : 0x01


Switch Ports Model              SW Version            SW Image                 
------ ----- -----              ----------            ----------               
*    1 26    WS-C3560-24PS      12.2(52)SE            C3560-IPSERVICESK9-M     


Configuration register is 0xF

Hall of Fame Super Gold

System returned to ROM by

System returned to ROM by power-on

Has anyone checked the stability of the power source?  A good test would be to put a UPS between the power outlet and the switch and see if the UPS kicks in.

 

New Member

the switch is permanently on

the switch is permanently on a UPS in fact the UPS has just been newly replaced.

Hall of Fame Super Gold

Then use raw power.

Then use raw power.

43
Views
0
Helpful
5
Replies
CreatePlease login to create content