Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Switch Command to set Port Channel Port number (Po#)

Hi All,

Is there a command I can use in my Cisco switch that will allow me to assign the port number I want for a port channel interface (Po#)?

For example:

int fa0/1

channel-group 1 mode on

 

Issuing that command automatically creates interface Po1.  However, for internal numbering convention ease, I want the port channel interface tied to channel-group 1 to be port 13 (Po13).

Is this possible?

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

The number in the interface

The number in the interface channel-group command corresponds to a specific po interface.

So if you've created po13, you will have to use the channel-group 13 on the physical interface. If you use channel-group 1 on the interface, it will assign that physical interface to po1. You can't tie the command in the physical interface to a different numbered po interface.

2 REPLIES
New Member

The number in the interface

The number in the interface channel-group command corresponds to a specific po interface.

So if you've created po13, you will have to use the channel-group 13 on the physical interface. If you use channel-group 1 on the interface, it will assign that physical interface to po1. You can't tie the command in the physical interface to a different numbered po interface.

New Member

Thank you.

Thank you.

310
Views
0
Helpful
2
Replies
CreatePlease login to create content